top of page
Blade Cut Resistance - Gloves Blade Cut Resistance

Blade Cut Resistance - Gloves Blade Cut Resistance

Apparatus suitable for determining the blade cut

Blade Cut Resistance Testing Equipment for leathers destined to the glove production industry

  • Technical specifications

    RESISTANCE OF GLOVES TO BLADE CUT Apparatus suitable for determining the blade cut according to UNI EN ISO 20388 standards complete with: - Gearmotor unit of adequate power - Blade support arm with 5-position bearing - Total load applied to the blade 5N - Rack of blade rotation-Sample closing system on drawing-50 mm stroke.Control panel:-Magnetothermal safety switch-Start - Stop - Manual buttons-4-digit digital cycle counter-Acquatest contact detection systemAccessories:Package of 6 pieces Normalized blade 45mm RB. in diameter

  • Technical Specifications

    Giuliani Tecnologie's R&D wishes to draw utilizer's attention on the recently designed and produced Blade Cut Resistance TestingEquiment for leathers destined to the glove production industry.A constant inquiry growth concerning tests to be performed on such matter,has been bringing to this newest project which will allow all producers to be able observing and verifying their products while subjected to severe physical stress action like, in this case, a deep blade cut. The system is designed to obtain a very comfortable test procedure while guaranteeing complete safety condition either before, during and after the test. Once positioned the sample, the equipment will feature the test automatically and, thanks to sophisticated sensors device, will automatically interrupt the process as the blade has been passing through the sample surface. The operator will be further aided in this circumstance by an acoustic test-end signal which will be working in contemporaneous time. The equipment is provided with a digital cycle counter to be able determining the desired range and achieve a complete test analysis.

    BLADE CUT RESISTANCE EQUIPMENT for gloves applications, designed as below described, in accordance with (except modifies) EN 388 :

    Properly powered engine reducer

    Blade support arm with n°5 positions  gear

    Total applied load on the blade: 5N

    Sample safety closure system 

    Motion run: 50mm

    POWER SYSTEM  220v 50hZ

bottom of page